Mazda 2002 6 Workshop Manual page 1175

A/C Compressor Installation Note
1. Remove the following amount of compressor oil from the new A/C compressor when replacing the A/C
compressor.
Compressor oil to be removed (approximate quantity)
120 ml {120 cc, 4.06 fl oz} – [compressor oil from old A/C compressor + 15 ml {15 cc, 0.5 fl oz}]
End Of Sie
CONDENSER REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system. (See
3. Remove the shroud panel. (See
Caution
• If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and
abnormal noise will occur. Always immediately plug all open fittings after removing any
refrigeration cycle parts to keep moisture or foreign material out of the cycle.
4. Remove in the order indicated in the table. Do not
allow compressor oil to spill.
1 Cooler pipe No.1
(See U–28 Refrigerant Lines Removal
(See U–29 Refrigerant Lines Installation
2 Cooler pipe No.2
(See U–28 Refrigerant Lines Removal
(See U–29 Refrigerant Lines Installation
3 Condenser
(See U–24 Condenser Installation
5. Install in the reverse order of removal.
6. Perform the refrigerant system performance test.
(See U–13 REFRIGERANT SYSTEM
PERFORMANCE TEST.)
Condenser Installation Note
1. When installing a new condenser, add a supplemental amount of ATMOS GU10 compressor oil inlet the
refrigerant cycle.
Supplemental amount (approximate quantity)
20 ml {20 cc, 0.7 fl oz}
End Of Sie
CONDENSER INSPECTION
1. Inspect for cracks, damage, and oil leakage.
• If any are found, replace the condenser.
2. Inspect for fins clogged by dust.
• If any are clogged, remove the dust from the fins.
3. Inspect for bent fins.
• If any are bent, use a flathead screwdriver to straighten them.
End Of Sie
U–24
BASIC SYSTEM
U–9
S–119 SHROUD PANEL
.
Note)
Note)
Note)
Note)
Note)
RECOVERY.) (See U–9
REMOVAL/INSTALLATION.)
A6E851661480W01
CHARGING.)
A6E8516W013
A6E851661480W02