Pid/Data Monitor Table - Mazda 2002 6 Workshop Manual

ON-BOARD DIAGNOSTIC [IMMOBILIZER SYSTEM]
End Of Sie
DTC TABLE
DTC
Security Security light flashing
light pattern
11
12
13
14
15
21
—
Note
• Perform the following if the security light stays on:
— If engine stalls, go to symptom troubleshooting NO.11 "ENGINE STALLS/QUITS, ENGINE RUNS
ROUGH, MISSES, BUCK/JERK, HESITATION/STUMBLE, SURGES" in. (See
STALLS/QUITS, ENGINE RUNS ROUGH, MISSES, BUCK/JERK, HESITATION/STUMBLE,
SURGES.)
— If engine won't start, go to symptom troubleshooting NO.6 "CRANKS NORMALLY BUT WILL NOT
START" in. (See
— If engine condition is normal but light stays on, inspect for continuity between the following wiring
harness and body ground: security light and PCM connector terminal 2W. Repair or replace the wiring
harness.
End Of Sie

PID/DATA MONITOR TABLE

PID mane (Description)
NUMKEYS
(Number of key stored in module)
WDS or
equivalent
B1681
B2103
B1600
B2431
B1602
B1601
B1213
— B1342
F–195 NO.6 CRANKS NORMALLY BUT WILL NOT
Unit
–
Description
Coil signal is not received.
Coil failure.
ID number signal is not
received.
Transponder programming
failure.
PCM received invalid format of
ID number from transponder.
PCM received incorrect ID
number from key
(transponder).
Number of valid keys is below
minimum.
PCM is defective.
Specification
Number of registered keys: 0—8
A6E817067000W02
Page
(See T–162 SECURITY LIGHT:
DTC 11 (WDS OR
EQUIVALENT: DTC B1681))
(See T–163 SECURITY LIGHT:
DTC 12 (WDS OR
EQUIVALENT: DTC B2103))
(See T–163 SECURITY LIGHT:
DTC 13 (WDS OR
EQUIVALENT: DTC B1600))
(See T–164 SECURITY LIGHT:
DTC 13 (WDS OR
EQUIVALENT: DTC B2431))
(See T–164 SECURITY LIGHT:
DTC 14 (WDS OR
EQUIVALENT: DTC B1602))
(See T–164–1 SECURITY
LIGHT: DTC 15 (WDS OR
EQUIVALENT: DTC B1601))
(See T–164–1 SECURITY
LIGHT: DTC 21 (WDS OR
EQUIVALENT: DTC B1213))
(See T–164–2 SECURITY
LIGHT: DTC - (WDS OR
EQUIVALENT: DTC B1342))
F–204 NO.11 ENGINE
START.)
A6E817067000W00
PCM terminal
–
T–161
T