Mazda 2002 6 Workshop Manual page 1190

SOLAR RADIATION SENSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the solar radiation sensor from the
dashboard using a tape-wrapped flathead
screwdriver.
3. Install in the reverse order of removal.
End Of Sie
SOLAR RADIATION SENSOR INSPECTION
1. Shine an incandescent light (60 W) on the solar radiation sensor from a distance of approximately 100 mm
{3.94 in}.
2. Connect positive (+) lead to terminal A and
negative (−) lead to terminal B of the solar
radiation sensor.
• If the output voltage is not above 0.45 V,
replace the solar radiation sensor.
End Of Sie
AMBIENT TEMPERATURE SENSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the radiator grille. (See
3. Remove in the order indicated in the table.
1 Ambient tenperature sensor connector
2 Ambient temperature sensor
4. Install in the reverse order of removal.
CONTROL SYSTEM
S–50 RADIATOR GRILLE REMOVAL/INSTALLATION.)
A6E854061751W01
A6E8540W017
A6E854061751W02
A6E8540W058
U
A6E854061764W01
A6E8540W018
U–39