PROTECTION OF VEHICLE
• Always be sure to cover fenders, seats and floor
areas before starting work.
End Of Sie
PREPARATION OF TOOLS AND MEASURING EQUIPMENT
• Be sure that all necessary tools and measuring
equipment are available before starting any work.
End Of Sie
SPECIAL SERVICE TOOLS
• Use special service tools or equivalent when they
are required.
End Of Sie
OIL LEAKAGE INSPECTION
• Use either of the following procedures to identify the type of oil that is leaking:
Using UV Light (Black Light)
1. Remove on the engine or transaxle.
Note
• Referring to the fluorescent dye instruction manual, mix the specified amount of dye into the engine oil or
ATF (or transaxle oil).
2. Pour the fluorescent dye into the engine oil or ATF (or transaxle oil).
3. Allow the engine to run for 30 minutes.
4. Inspect for dye leakage by irradiating with UV light (black light), and identify the type of oil that is leaking.
GI–12
FUNDAMENTAL PROCEDURES
FUNDAMENTAL PROCEDURES
A6E201400004W01
X3U000WAG
A6E201400004W02
X3U000WAH
A6E201400004W03
X3U000WAJ
A6E201400004W04