• If removed, these parts should be replaced with new ones:
— Oil seals
— Gaskets
— O-rings
— Lockwashers
— Cotter pins
— Nylon nuts
• Depending on location:
— Sealant and gaskets, or both, should be applied to specified locations. When sealant is applied, parts
should be installed before sealant hardens to prevent leakage.
— Oil should be applied to the moving components of parts.
— Specified oil or grease should be applied at the prescribed locations (such as oil seals) before reassembly.
End Of Sie
ADJUSTMENT
• Use suitable gauges and/or testers when making
adjustments.
End Of Sie
RUBBER PARTS AND TUBING
• Prevent gasoline or oil from getting on rubber
parts or tubing.
End Of Sie
FUNDAMENTAL PROCEDURES
GI
WGIWXX0032J
A6E201400004W12
X3U000WAS
A6E201400004W13
WGIWXX0034E
GI–15