Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
Open circuit
• If there is no continuity, there is an open circuit. Repair or replace the wiring harness.
- Neutral switch terminal A and PCM terminal 1AB
- Neutral switch terminal B and body GND
Short circuit
• If there is continuity, there is a short circuit. Repair or replace the wiring harness.
- Neutral switch terminal A and body GND
- Neutral switch terminal B and power supply
CLUTCH PEDAL POSITION (CPP) SWITCH
Note
• Before performing the following inspection, make sure to follow the procedure as indicated in
the troubleshooting flowchart. (See
Continuity Inspection
1. Remove the CPP switch.
2. Verify that the continuity between CPP switch terminals A and B is as indicated in the table.
• If not as indicated in the table, replace the CPP switch. (See
REMOVAL/INSTALLATION.)
• If the monitor item condition/specification (reference) is not within the specification, even though
there is no malfunction, perform the "Circuit Open/Short Inspection".
Downloaded from
INSPECTION [Z6]
Troubleshooting
https://carmanualshub.com/
Procedure.)
CLUTCH PEDAL
- automotive repair manuals website
B3E014018660W02