Q
5 A
B
-7 7 1
r r r
/
E
C '
I
—
1
D
Q -2 0
CRUISE CONTROL SYSTEM
CLUTCH SWITCH (MTX)
Removal / Installation
. Disconnect the clutch switch connector.
1
2. Turn the clutch switch 90° and pull it out.
3. Install in the reverse order of removal.
Inspection
. Measure the clutch pedal height. If not as specified,
1
loosen locknut A. Adjust the pedal height by turning
adjusting bolt B. Retighten locknut A when the specified
height is reached.
Pedal height: 186—211 mm {7.32—8.31 in}
. Measure the clutch pedal free play. If not as specified,
2
adjust loosen locknut C and turn push rod D. Then
retighten the locknut.
Pedal free play: 1.0—3.0 mm {0.04—0.12 in}
3. Disconnect the clutch switch connector.
4. Check for continuity between the switch terminals.
Clutch pedaT~'-^~^_
Depressed
Released
5. If not as specified, replace the clutch switch.
(Refer to the 1996 626/MX-6 Workshop Manual, section F.)
(with carpet)
i na 1
c
B
------
0
O
0 - 0 : Continuity
D
E
---
O
—
o