Notes And Restrictions On The Use Of The Copy Feature - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

16 Appendix


 Opening and Closing of the Document Cover during the Power Saver Mode
If you open the document cover during the Power Saver mode, and then start scanning a
document immediately after the machine exits the mode, the detection error of a document
size may occur. In this case, enter the document size manually. It takes a few seconds before
the machine can detect a document size automatically. This detection error will not occur if
you load a document, close the document cover, and wait for a few seconds before start
scanning a document.
Note
 About View Image Generation
It may take time for generating view images depending on the type of document. If you
want to speed up the printing process or there is no need for displaying view images, you
can disable the image generation setting of the print driver.
Note

Notes and Restrictions on the Use of the Copy Feature

 Copy Feature
The machine does not offer the Improves Fit feature.
 Meter Count for Dual Color and Single Color Copies
Dual color and single color copies are counted as color copies.
 Color Effect for Dual Color Copy
To extract colors for dual color copy, adjusting the colors of the document is required in
advance.
Our service representative performs the adjustment. Contact our Customer Support Center.
 Auto Contrast
The machine does not offer the [Auto Contrast] feature for [Color Effects].
 Pages per Side for Black & White and Color Mixed Documents and Meter Count
If you copy a document that contains black & white and color pages by specifying [Pages
per Side], an output sheet that has both black & white and color pages will be counted as a
color page.
 Copy and Simple Copy
16
You cannot switch the screen between the Copy and Simple Copy services. Return to the
Services Home screen, and then select a service. In that case, the settings specified in either
service are cleared.
 ID Card Copy

730
When [Tools] > [System Settings] > [Connectivity & Network Setup] > [Port Settings] >
[USB] > [USB - Print Mode] is set to any option other than [Auto], exiting the Power Saver
mode activates the entire machine.
The output device is activated when Secure Print is executed using job tickets of
ContentsBridge Utility.
• When you approach the machine from undetectable area, the power saver will not be deactivated
even when Smart WelcomEyes is enabled.
• The print driver settings have priority over the machine settings.
The machine does not shift the ID card image to the center of the output in any
magnification ratio and image size you specified.