Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 222

5 Tools
 IPv6 Address Manual Configuration
Allows you to select whether or not to configure the IPv6-address settings manually.
 Manually Configured IPv6 Address
This setting is configurable when [IPv6 Address Manual Configuration] is set to [Enable].
Specify an IPv6 address.
Note
 Manually Configured IPv6 Address Prefix
This setting is configurable when [Manually Configured IPv6 Address] is set. Specify a prefix
length from 0 to 128.
 Manually Configured IPv6 Gateway
This setting is configurable when [Manually Configured IPv6 Address] is set. Specify a
5
gateway address.
Note
 IPv6 - DNS Server Setup
Set the DNS server for IPv6.
 Get IP Address from DHCP
Set whether or not to automatically obtain the address of the DNS server from the DHCP
server.
 Preferred DNS Server IP Address, Alternate DNS Server 1 IP Address, Alternate DNS Server
2 IP Address
When [Get IP Address from DHCP] is set to [Disabled], manually set the DNS server
address.
Specify alternate DNS server addresses for [Alternate DNS Server 1 IP Address] and
[Alternate DNS Server 2 IP Address].
 Automatically Configured IPv6 Address
Displays the following addresses, which are automatically assigned.
Link-local address

 Auto Stateless Address 1 and Prefix Length
 Auto Stateless Address 2 and Prefix Length
 Auto Stateless Address 3 and Prefix Length
 Auto Gateway Address
 IPv6 - IP Filter
Select whether or not to limit the IPv6 addresses that can access the machine.
222
• To set the IPv4 IP addresses that the machine accepts connection from, use [IP Filtering] in
CentreWare Internet Services. For more information, refer to the help of CentreWare Internet
Services or refer to "CentreWare Internet Services Settings" (P.335).
• When [IP Filtering] is enabled, make sure to switch the FTP transfer mode to [Active Mode] to
transfer the scanned image from the machine via FTP. You can switch the FTP transfer mode from
CentreWare Internet Services.
• Enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
• Specify an address using alphanumeric characters (0 to 9, and A to F) and colons (:). If you mistyped
a character on the screen, select [Backspace] to delete the character.
• Enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.