Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 558

15 Problem Solving
Error Code
024-705 [Cause]
[Remedy] Delete the document in the folder of the machine, and then select [Store to Folder]
024-706
[Cause]
[Remedy] Set [Allow User to Disable Active Settings] to [Disable Active Settings] under [Tools]
024-742
[Cause]
[Remedy] Change the printer properties setting to split the pages appropriately to create separate
024-746 [Cause]
[Remedy] Confirm the print data.
024-747
[Cause]
[Remedy] Confirm the print data, and try printing again.
024-748
[Cause]
[Remedy] Set [Bates Stamp - Number of Digits] to the value specified in [Starting Number] or to
024-775 [Cause]
[Remedy] Change the printer properties setting to split the pages appropriately to create separate
025-596 [Cause]
025-597
[Remedy] Replace the hard disk.
026-400 [Cause]
[Remedy] Disconnect the third or more devices so that the number of connected devices becomes
026-401 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
026-700
[Cause]
15
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
026-701
[Cause]
[Remedy] Wait for a while and execute the operation again. If the only one query is being
558
Cause and Remedy
The template of the specified force annotation was not found in the machine.
again from the print driver to store the document.
A print job from Denshi-Pen is sent when [Force Watermark - Client Print] or [Force
Secure Watermark] > [Client Print] is set to [On].
>[Authentication / Security Settings].
Booklet printing was specified for printer properties, but the number of print pages for
the job exceeded the maximum number allowed for booklet creation.
volumes, or to cancel the booklet creation setting.
The specified paper type is not compatible with the specified paper size, paper tray,
output tray, or 2 sided printing.
Incompatible print parameters are used. The combination of the specified features such
as Document Size, Paper Size, Paper Tray, 2 sided printing, and Output Tray is
incompatible.
The number of digits specified in [Bates Stamp - Number of Digits] screen does not
match the value specified in [Starting Number].
[Auto Assign].
Booklet printing was specified for printer properties, but the number of print pages for
the job exceeded the maximum number allowed for booklet creation.
volumes, or to cancel the booklet creation setting.
An error occurred with the hard disk.
More than two devices are connected to the USB host port.
two. If the error still is not resolved, switch off the machine power, make sure that the
touch screen is blank, and then switch on the machine power.
The image may be misaligned during processing the print job.
on the machine power. When the misalignment is large, contact our Customer Support
Center.
By Address Book operation, the machine received an unsupported protocol from the
LDAP server.
Support Center.
The number of queries submitted to the Address Book exceeded the machine's
processing capability.
submitted to the Address Book, the machine's software may be defective. Contact our
Customer Support Center.