Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 713

Parameter Item No.
Print control 159 (Scaling)
160
(Scaling mode)
161
(Active area
determination
command)
162
(Paper margin)
163
(Image
enhancement)
Stapling 164
Manual feed tray 165
check indicator
Punching 166
Number of holes 167
Sets whether the original size is enlarged or reduced so that the document size
fits the paper size.
[0] : OFF
[1] (Default) : ON
Selects the document size for auto scaling: A series paper (A0, A1, A2, A3, A4,
and A6) or the active coordinate area which is determined accordance with
the setting selected in [Area Determination Mode].
[0] (Default) : Paper Size
[1] : Active Coordinate Area
Note • [Active Coordinate Area] can be selected only when [Auto layout] is set to
[ON]. When [OFF] is selected, [Scaling mode] becomes [Paper Size].
• The setting of the scaling mode is valid when [Document size] is set to
[Auto].
Sets the method to obtain the active coordinate area when auto scaling is
being used.
[0] (Default) : Auto
[1] : PS
[2] : IW
[3] : IP
[4] : Adapted
Note • The setting of the active area determination command is valid when
[Document size] is set to [Auto].
Sets the paper margin when auto scaling is being used.
[0] - [99] (Default: 0) : 0 to 99 mm
Note • The setting of the paper margin is valid when [Document size] is set to
[Auto].
Sets whether to perform image enhancement, which artificially increases the
resolution of an image and smooth its edges.
[0] : OFF
[1] (Default) : ON
Sets the stapling position.
[0] (Default) : None
[1] : Top Left
[2] : Top Double
[3] : Top Right
[4] : Left Double
[5] : Right Double
[6] : Bottom Left
[7] : Bottom Double
[8] : Bottom Right
[9] : Center
[0] : None
[1] (Default) : Yes
Select the position for punching holes.
[0] : None
[1] (Default) : Top
[2] : Bottom
[3] : Left
[4] : Right
Select the number of punch holes.
[0] (Default) : 2 holes
[1] : 3 holes
[2] : 4 holes
HP-GL/2 Emulation
Value
16
713