Replacing Staple Cartridge (For C3 Finisher Or C3 Finisher With Booklet Maker) - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

3 Maintenance
4
Pinch both sides of the empty staple case with
your fingers (1), and remove the staple case
from the cartridge (2).
5
Insert the front side of the new staple case into
the staple cartridge (1), and then push the rear
side into the cartridge (2).
3
6
Push the staple cartridge into the finisher until
it clicks into place.
7
Close the finisher front door.
Note
Replacing Staple Cartridge
(for C3 Finisher or C3 Finisher with Booklet Maker)
When the C3 Finisher (optional) or the C3 Finisher with Booklet Maker (optional) is installed
and the staple cartridge needs to be replaced, a message appears on the touch screen.
When this message appears, load a new staple case into the staple cartridge.
The Staple Cartridge [R1] is running out of
staples. Check the Staple Cartridge [R1] and
order staples.
The Staple Cartridge [R1] is out of staples or not
fully inserted. Check the Staple Cartridge [R1].
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Note
90
• If the front door is not closed completely, a message appears and the machine will remain paused.
Message
Use only staple cartridges recommended by Fuji Xerox.
• If the staple cartridge was not replaced properly, the message remains on the touch screen. Follow
the procedure and replace the staple cartridge again.
• The 50 sheets staple cartridge is installed as standard in C3 Finisher or C3 Finisher with Booklet
Marker. When you install the C3 Finisher Staple Unit 65 Sheets (optional) remove the 50 sheets
staple cartridge. After removing the 50 sheets staple cartridge, be sure to keep it.
Solution
Prepare new staples.
Note • Staples cannot be replaced yet.
Replace staples with new ones.