Copy Control - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

5 Tools

Copy Control

You can configure settings related to copy operation control.
Memory Full Procedure
If there is insufficient hard disk memory while scanning a document, a screen appears
asking you how you want to handle the partially stored data.
Set the process you want the machine to perform for the partially stored data after a certain
time has elapsed in the confirmation screen.
You can set the time until the memory full procedure is carried out. For more information, refer to "Auto Job Release" (P.158).
 Delete Job
Deletes the data partially stored.
 Run Job
Treats the read-in data as valid, and start copying the document partially stored.
Maximum Stored Pages
Set the maximum number of pages stored for a copy document. You can set from 1 to 999
pages.
Auto Paper Off
5
Select the tray used when [Auto Select] of [Paper Supply] in the [Copy] screen is cancelled.
[Auto Select] of [Paper Supply] is cancelled when [Auto %], [Auto X-Y %] for [Independent
X-Y %], or [Slight Reduction (Improves Fit)] is selected.
Mixed Size Originals - 2 Sided Copy
Specify paper to copy side 2 of a document: in 2 sided copying, if the size of side 1 and side
2 of a document is different, and the machine detects different paper size for sides 1 and 2.
Important • When the side 1 and side 2 are different sizes and if the side 2 is copied on the sheet on which the
 Copy to new sheet
Side 2 is copied as side 1 on a new sheet of paper.
 Copy to Side 2
Side 2 is copied on the reverse side of side 1 without changing paper size.
Fine-tune 100%
You can fine-tune magnification when copying at 100% (actual size). The set value is
applied to [100%] in the [Copy] screen is set to 100%.
Set the value in the X/Y direction between 98 and 102% in 0.1% increments.
Important • This feature is applied only when a copy is made using the document glass. This setting is not
Note
ID Card Copy - Reduce/Enlarge
Set the copy magnification ratio when to copy ID cards. Selecting [Allow to Change] allows
you to specify the ratio between 25 to 400 % in 1 % increments.
Note
210
side 1 has been printed, a part of the image may be missing.
reflected in the magnification (100%) under [Independent X-Y%] or [Calculator %].
• A magnification displays [100%] even if [Fine-tune 100%] is selected.
• The machine may copy an ID card in a different orientation from the original orientation depending
on the magnification ratio you specified.