Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 160

5 Tools
Power Saver Timers
The Power Saver mode has two modes: the Low Power and Sleep modes. When a specified
period of time has elapsed, the machine switches to these modes in the following order to
reduce power consumption.
Last operation on the machine  Low Power mode  Sleep mode
For more information on the setting procedure, refer to "Power Saver Mode" (P.25).
Note
 From Last Operation to Low Power Mode
Specify a time period between 1 and 240 minutes in 1 minute increments to enter the Low
Power mode after the last operation.
Note
 From Last Operation to Sleep Mode
Specify a time period between 1 to 240 minutes in 1 minute increments to enter the Sleep
mode after the last operation.
Note
5
Enter Power Saver after Printing Ends
Set when to enter the Power Saver mode after a print job or printing of fax/Internet fax
documents is finished.
 15 seconds after Auto Printing Ends
Enters Sleep mode in 15 seconds.
 According to Power Saver Timer Settings
Enters Low Power mode or Sleep mode according to the period specified in [Power Saver
Timers].
For more information on the setting procedure, refer to "Power Saver Mode" (P.25).
Power Saver Deactivation
Select whether to disable the Power Saver mode fully or partially when exiting the mode.
 Deactivate All
All devices of the machine exit the Power Saver mode.
 Deactivate Partially As Required
Only the devices necessary for the operation exit the Power Saver mode.
You can select from [Always On] or [When Printing / Job Auto Processing].
Scheduled Power Off
You can set a time for the machine to be automatically turned off.
 Disabled
Does not turn off the machine automatically.
160
• You cannot configure the machine not to switch to the Low Power mode or the Sleep mode.
• The timer does not start counting until the operator leaves the detectable area of Smart
WelcomEyes. The Access Lamp lights up while the machine detects human presence.
• Configure the [From Last Operation to Sleep Mode] time to be same or longer than the [From Last
Operation to Low Power Mode] time.
• The machine enters Sleep mode without entering Low Power mode when the [From Last Operation
to Low Power Mode] time is same as the [From Last Operation to Sleep Mode] time.
• The timer does not start counting until the operator leaves the detectable area of Smart
WelcomEyes. The Access Lamp lights up while the machine detects human presence.