Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 596

15 Problem Solving
Error Code
117-343 [Cause]
[Remedy] For 1, set other than [Transfer Per Job Basis] for [Log to Transfer].
117-347 [Cause]
[Remedy] Contact our Customer Support Center.
117-348
[Cause]
117-350
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
118-310
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
118-311 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
121-310 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
121-311 [Cause]
[Remedy] Once IC Card Reader (optional) is connected to the machine, the machine
121-312
[Cause]
[Remedy] Switch on the machine power without connecting the device for EP system, and then set
121-313
[Cause]
[Remedy] Switch on the machine power without connecting the device for EP system, and then set
15
596
Cause and Remedy
Probable causes are follows.
1)When [Image Log Control] on Tools is invalid and [Enabled] is set for [Log Transfer]
under [Transfer Image Log], [Transfer Per Job Basis] is set for [Logs to Transfer].
2)When [Transfer Image Log] is invalid (the hard disk is not installed), [Log Transfer] is
set to [Enabled].
For 2, install the hard disk to the machine, or set [Pause] for [Logs To Transfer].
The life of the component which cannot be replaced is expired. The machine itself needs
to be replaced.
The unformatted SD card used in the other machine is installed.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
An error occurred in the machine.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
An error occurred during software processing.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
An error occurred in the machine.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
An error occurred between the machine and the device connected.
automatically changes the [Passcode Entry for Smart Card Login] setting to [On] under
[Tools] > [Authentication/Security Settings] > [Authentication] > [Passcode Policy].
Change the setting as required.
An error occurred between the machine and the device connected.
[Login Type] to any option other than [Login to Remote Accounts] under [Tools] >
[Authentication/Security Settings] > [Authentication].
An error occurred between the machine and the device connected.
[Login Type] to any option other than [Login to Remote Accounts] under [Tools] >
[Authentication/Security Settings] > [Authentication].