Booklet Position Adjustment - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

6
Select [Long at Left] or [Long at Right], and
enter the value you measured in the step 5 in
[Value A Before Adjustment].
7
Select [Adjust].
8
Select [Sample Printout] again.
9
Select the tray in which you loaded paper and press the <Start> button.
The sample is printed.
10
Select [Close].
11
Confirm the result of sample printout.
12
Adjust the alignment again if necessary. (Steps 5 to 11)
13
Select [Save].
14
Select [Close] until the Services Home screen is displayed.
Note

Booklet Position Adjustment

Adjust the booklet position.
1
Select [Booklet], and then select [Change
Settings].
2
Select [Sample Printout].
3
Select the tray in which you loaded paper,
select [2-Sheet Stack], and press the <Start>
button.
The sample is printed.
• When you configure settings under [System Settings] or [Setup] and then press the <Services Home>
button, the screen directly goes back to the Services Home screen.
Fold Position Adjustment
669
16