Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 576

15 Problem Solving
Error Code
033-549 [Cause]
[Remedy] Wait for a while, and execute the operation again.
033-550 [Cause]
[Remedy] Wait until the job being communicated completes, and then execute the operation
033-551 [Cause]
[Remedy] Wait for a while, and execute the operation again.
033-552
[Cause]
[Remedy] Confirm the model of the other machine, and execute the operation again. If receiving,
033-553 [Cause]
[Remedy] If necessary, check whether the sender entered an invalid F-code.
033-554 [Cause]
[Remedy] No measure is required.
033-555 [Cause]
[Remedy] Check whether the sender specified an incorrect machine password.
033-556 [Cause]
[Remedy] If necessary, check whether the correct machine password has been instructed to the
033-557 [Cause]
[Remedy] Wait until the number of jobs awaiting transmission decreases, or reduce the number of
033-558 [Cause]
[Remedy] Ask the sender to set a remote ID. If necessary, set the machine to receive even when a
033-559 [Cause]
[Remedy] An error occurred during operation of the maintenance system by Fuji Xerox. When the
033-560
[Cause]
033-561
[Remedy] This is an error occurring during remote maintenance work by Fuji Xerox. No measure is
033-562
15
033-563 [Cause]
[Remedy] Take one of the following measures:
033-564 [Cause]
[Remedy] Wait for a while, confirm the fax service settings and the fax number, and then send
576
Cause and Remedy
Cannot use the Fax service because of causes such as memory is insufficient.
Cannot execute another job because fax communication is in progress.
again.
You attempted to change a job immediately before fax or telephone communication
completed.
The total quantity of error lines detected with G3 exceeded the set value.
ask the sender to send again.
This machine does not have confidential or relay function. The F-code sent from the
other machine contains an instruction for a function not supported by the machine.
The password was omitted or did not match in fax communication.
The password received from the other machine did not match the password for
receiving faxes on the machine.
The password sent to the other machine did not match the password for receiving faxes
on the other machine.
other machine.
The number of services or of recipients exceeds the maximum limit.
recipients, and then send again.
The machine is set to reject faxes without a remote ID, and a remote ID was not sent
from the other machine.
remote ID is not sent.
The authentication ID is incorrect.
communication line is available, contact our Customer Support Center.
An error occurred during remote maintenance work.
required.
Paper that can print faxed documents is not loaded in a tray.

Specify the paper size.

Confirm whether the paper tray is set correctly.
The machine was turned off during communication.
again if sending. If the error still is not resolved, contact our Customer Support Center.