Authentication/Security Settings; System Administrator Settings - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

5 Tools

Authentication/Security Settings

In [Authentication/Security Settings], you can configure the registration and authentication
of a user and security settings.
For more information about the feature, refer to "Authentication and Accounting Features" (P.429).
The following shows the reference section for each setting.

System Administrator Settings................................................................................................................................................. 322

Authentication ............................................................................................................................................................................. 323
Allow User to Disable Active Settings ..................................................................................................................................... 331
Job Status Default ....................................................................................................................................................................... 331
Overwrite Hard Disk .................................................................................................................................................................... 332
1
On the [Tools] screen, select [Authentication/Security Settings].
For the method of displaying the [Tools] screen, refer to "System Settings Procedure" (P.138).
2
Select an item to set or change.
System Administrator Settings
In [System Administrator Settings], you can set the system administrator ID and passcode.
5
We recommend setting the system administrator ID and passcode to prevent unauthorized
setting changes and ensure security.
System Administrator's Login ID
Set the system administrator's user ID. Enter the ID from 1 to 32 single-byte characters.
Note
1
Select [System Administrator's Login ID].
2
Select [On].
3
Select [Keyboard].
4
Enter the system administrator's ID with up to
32 characters, and then select [Save].
5
Repeat steps 3 and 4 to re-enter the same
system administrator's ID in [Re-enter System
Administrator's Login ID].
6
Select [Save].
7
A confirmation window appears. Select [Yes] to confirm your entry.
System Administrator's Passcode
Set the passcode for the system administrator.
Setting a passcode is strongly recommended to enhance security.
Note
The system administrator's passcode set here is used when [Passcode Entry for Control
Panel Login] is set to [On] under [Authentication/Security Settings] > [Authentication] >
[Passcode Policy].
322
• The default of the system administrator's user ID is "11111".
• The default of the system administrator's passcode is "x-admin".