Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 244

5 Tools
Job Ticket Memory
Specify the amount of memory to use for job tickets from 0.25 to 8.00 MB in 0.25 MB
increments.
Note
Receiving Buffer - Parallel
Set the receiving buffer for parallel.
You can specify a value from 64 to 1024 KB in 32 KB increments.
Receiving Buffer - USB
Set the receiving buffer for USB.
You can specify a value from 64 to 1024 KB in 32 KB increments.
Receiving Buffer - LPD
Note
 No Spooling
Does not use spooling. While LPD printing is performed for one client, data cannot be
5
received over the same interface from another client.
Specify a value for the dedicated LPD receiving buffer memory capacity from 1024 to 2048
KB in 32 KB increments.
 Spool to Memory
Carries out spooling. The receiving buffer for spooling uses memory. When this setting is
selected, specify the memory capacity of a receiving buffer for spooling from 0.50 MB to
32.00 MB in 0.25 MB increments.
Note that print data exceeding the memory capacity set is not accepted. In such cases,
select [Spool to Hard Disk] or [No Spooling].
 Spool to Hard Disk
Carries out spooling. The receiving buffer for spooling uses the hard disk.
Receiving Buffer - IPP
 No Spooling
Does not use spooling. While IPP printing is performed for one client, data cannot be
received over the same interface from another client.
Specify a value for the dedicated IPP receiving buffer memory capacity from 64 to 1024 KB
in 32 KB increments.
 Spool to Hard Disk
Carries out spooling. The receiving buffer for spooling uses the hard disk.
Receiving Buffer - Port 9100
Set the Port9100 receiving buffer.
Specify a value from 64 to 1024 KB in 32 KB increments.
244
• The maximum amount of memory you can allocate varies according to the amount of free space
available in memory.
• You may not be able to change the [Receiving Buffer - LPD] setting because of the setting of [LPD
Print Queue].
For more information on LPD Print Queue, refer to "LPD Print Queue" (P.248).