Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 214

5 Tools
Parallel
 Port Status
Select [Enabled] to use a parallel interface.
 Print Mode
Select the printer language use on the machine. Selecting [Auto] enables the machine to
automatically determine and use the most suitable language to print data received from
the host device.
 PJL
PJL (Printer Job Language) is a job control language and a PJL command is data prepended
to the top of the print jobs. Usually select [Enabled].
 Auto Eject Time
Configure the time that the data so far received by the machine will automatically be
printed since data is no longer sent to the printer.
You can enter a time between 5 and 1275 seconds in 5 seconds increments.
 Adobe Communication Protocol
 Standard
Select this when the output protocol of the print driver is in the ASCII format.
5
 Binary
Select this when the output protocol of the print driver is in the BCP format.
 TBCP
Select this when the output protocol of the print driver is in the TBCP format.
 Bi-directional Communication
Specifies whether or not to allow bi-directional communications.
USB
 Port Status
Select [Enabled] to use a USB interface.
 Print Mode
Select the printer language use on the machine. Selecting [Auto] enables the machine to
automatically determine and use the most suitable language to print data received from
the host device.
 PJL
PJL (Printer Job Language) is a job control language and a PJL command is data prepended
to the top of the print jobs. Usually select [Enabled].
 Auto Eject Time
Configure the time that the data so far received by the machine will automatically be
printed since data is no longer sent to the printer.
You can enter a time between 5 and 1275 seconds in 5 seconds increments.
214