Server Setup - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

Server Setup

This section describes how to register a server on access web applications.
Note
1
Select [Server Setup].
2
Select an access destination you want to register, and then select [Change Settings].
3
Enter the URL of the access destination, if you register an access destination in a new entry.
 URL
Enter the URL of the access destination with up to 256 single-byte characters, and select
[Save]. URL must begin with the type of the protocol used.
Use the version of a web application that is set [Web Applications Version] in "Web Browser
Setup" (P.289).
For example:
 http://www.example.com
 http://192.0.2.1 (IPv4)
 http://[2001:DB8::1234] (IPv6)
 https://www.example.com
 https://192.0.2.1 (IPv4)
 https://[2001:DB8::1234] (IPv6)
When you connect the server specifying the version of the web application to be used, enter
the version after the protocol type. The setting made here takes precedence of the setting
made in [Web Applications Version].
For example:
When specified with V2

- http-v2://www.example.com
- http-v2://192.0.2.1 (IPv4)
- http-v2://[2001:DB8::1234] (IPv6)
 When specified with V4
- http-v4://www.example.com
- http-v4://192.0.2.1 (IPv4)
- http-v4://[2001:DB8::1234] (IPv6)
 When specified with V5
- http-v5://www.example.com
- http-v5://192.0.2.1 (IPv4)
- http-v5://[2001:DB8::1234] (IPv6)
Note
4
Configure other settings as necessary.
 Server Name
Enter the access destination name with up to 32 single-byte characters.
Web Applications Service Setup (ApeosPort Series Models Only)
• If there are one or more servers to register, it is helpful to assign the servers to the buttons displayed
on the Services Home screen. For information on changing the buttons on the Services Home screen,
refer to "Customizing the Control Panel" (P.29).
• When the URL is specified with V3, V4 is used for connection.
• Begin with "https" for a protocol with an encryption feature.
5
287