Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 502

15 Problem Solving
Error Code
012-291 [Cause]
012-292
[Remedy] Close the finisher front cover. If the error still is not resolved, contact our Customer
012-295
012-296
012-297
012-298
012-299
[Cause]
[Remedy] The error occurs when the first paper in a setting that comes to a finisher tray is taken
012-319
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
012-326
[Cause]
[Remedy] Make sure that a paper folding unit is plugged in. Switch off the machine power, make
012-334 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
012-402 [Cause]
[Remedy] Install the hole punch waste container. When the same message is displayed even after
012-500 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
013-210 [Cause]
013-211
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
013-212
013-213
013-220
15
502
Cause and Remedy
The finisher front cover is open.
Support Center.
Finisher malfunction
out before completely coming out to the finisher tray. Make sure to take out the paper
after it completely comes out. Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power. If the error still is not resolved,
contact our Customer Support Center.
Finisher malfunction
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
Finisher malfunction
sure that the touch screen is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support Center.
An error occurred.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
The hole punch waste container of the finisher is not installed.
you install the hole punch waste container, remove the container, and then install it
again.
An error occurred in the finisher.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
An error occurred in the Booklet Unit.
on the machine power. If the error still is not resolved, contact our Customer Support
Center.