Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 327

 Failed Access Log
Set the failure count to detect unauthorized access. An error is logged if authentication fails
the number of times specified here within a predetermined time (10 minutes).
 Logout Confirmation Screen
Set whether or not to display a logout confirmation screen every time a user session ends.
 User ID for Login
Set whether or not to make the user ID entry field on the user login screen case-sensitive.
When you select [Case Sensitive], authentication is performed using the User ID as
registered (including upper and lower cases). When you select [Non-Case Sensitive],
authentication is performed with case ignored even if the user ID has both upper and lower
cases.
Important • Do not change the setting while a file is stored for the Private Charge Print. Otherwise, you may
encounter problems, such as being unable to print. Change the setting after the machine prints all
the files stored.
• Do not select [Case Sensitive] when the machine stores user IDs such as "ABC" and "abc" which are
regarded as the same ID under the setting. If you select [Case Sensitive], it may cause the problem
and those IDs may not be displayed. Before you select the setting, correct those user IDs to
distinguish them.
 When Smart Card Reader is Connected
Set whether or not to enable user ID authentication when [Login to Local Accounts] is
selected and the smart card reader is connected.
When [Smart Card Login] is selected, user ID authentication cannot be used. When [Smart
Card or Control Panel Login] is selected, both smart card authentication and user ID
authentication can be used.
 Account Auto Setup for Card Login
Set whether or not to register new user information when [Login to Local Accounts] is
selected and an unregistered user holds a card over the smart card reader.
When [Disabled] is selected, the machine does not register the user. When [Enabled] is
selected, the machine registers the user automatically.
Note • When [Enabled] is selected, [User Name], [Service Access], and [Add User To Authorization Group]
will be displayed.
• Set the user name by selecting [User Name].
• When [Service Access] is selected, [Copy], [Fax], [Scan], and [Print] will be displayed.
You can set [Feature Access] and [Change Account Limit] for each item.
• When [Add User To Authorization Group] is selected, you can select a user role and an authorization
group for the user.
• When [Passcode Entry for Smart Card Login] under [Tools] > [Authentication/Security Settings] >
[Authentication] > [Passcode Policy] is set to [On], you need to enter the passcode twice for the auto
assign.
 Guest User
Set whether or not to permit a guest user when [Login to Remote Accounts] is selected. Set
the guest user passcode from 4 to 12 digits.
Note • Access restriction for each service cannot be specified for the guest user.
 Use of Smart Card
Set whether or not to use smart card authentication.
 Smart Card Link Mode
Set whether or not to require a passcode for smart card authentication when [Login to
Remote Accounts] is selected.
Authentication/Security Settings
327
5