Smtp Server Settings - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

5 Tools
 Server Name/IP Address
Enter a server name or IP address with up to 128 characters, and then select [Save].
 Port Number
Enter a port number from 1 to 65535.
The default value is 110.
Important • Do not use the numbers assigned to the other ports.
 Polling Interval
Set the interval for checking the e-mail on the POP3 server from 1 to 120 minutes in 1
minute increments.
 Login Name
Enter the name to login to the POP3 server with up to 64 characters.
 Password
Enter a password for the POP3 server with up to 64 characters.
Enter the same password in [New Password] and [Retype Password] using the numeric
keypad displayed by selecting [Keyboard]. If you do not set the password, leave the text
boxes blank and select [Save].
 POP Password Encryption
5
Select [On (APOP)] to encrypt the password.

SMTP Server Settings

Set the SMTP server. In [SMTP Server Settings], you can set the following items.
You can check the connection between the machine and the SMTP server by sending a test
mail to the e-mail address specified in [Connection Test]. Selecting [Connection Test] >
[Print SMTP Comm. Report] outputs the report that shows the contents of protocol of the
SMTP communication transmitted and received by the machine.
Note
 SMTP Server Name/IP Address
Enter a server name or IP address, and then select [Save]. Up to 128 characters are allowed.
 SMTP Server Port Number
Enter a port number in the range from 1 to 65535.
The default value is 25.
Important • Do not use the numbers assigned to the other ports.
 E-mail Send Authentication
Select one from [Off], [POP before SMTP], or [SMTP AUTH].
Note
230
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
• If [POP before SMTP] is selected, the POP3 settings must be set.
• AUTH GSSAPI (only for Kerberos), AUTH NTLMv2, AUTH NTLMv1, AUTH PLAIN, AUTH-LOGIN, or
AUTH CRAM-MD5 can be used as an authentication method.