Changing The Paper Size For Tray 4 (When Tandem Tray Module Is Installed) - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

2 Paper and Other Media
4
Load and align the edge of the paper against
the left edge of the tray, with the side to be
copied or printed on facing down.
Important • Do not load paper above the maximum fill
5
While pinching the paper guide, lightly align the edge to the edge of the paper.
6
Push the tray in gently until it stops.
Note
7
Specify the type of loaded paper when you have changed the paper type.
For information on how to set the paper types, refer to "Changing the Paper Settings" (P.72).
2

Changing the Paper Size for Tray 4 (When Tandem Tray Module is Installed)

The following describes how to change paper size in Tray 4 when the Tandem Tray Module
is installed.
1
Pull out Tray 4 until it stops.
Make sure to pull out the tray slowly.
When the tray is being pulled out with
force, the tray may possibly hit your
knees or other parts of your body
causing injuries.
Important • While the machine is processing a job, do not pull out the tray that is being used for the job.
2
Remove any paper loaded in the tray.
3
Pinch the paper guide and slide it to the desired
paper size.
68
line. It may cause paper jams or machine
malfunction.
• Affix the paper size label to the front of the paper tray.
CAUTION
• To prevent paper jams or erroneous detection of loaded paper in a tray by the machine, do not add
paper on top of any remaining paper in the tray.