Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 590

15 Problem Solving
Error Code
099-373 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
102-356 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
103-310 [Cause]
103-311
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
103-312
103-313
103-314
112-700 [Cause]
[Remedy] Empty the hole punch waste container.
For more information on how to empty the hole punch waste container, refer to "Emptying the Hole Punch Waste
Container (for C3 Finisher or C3 Finisher with Booklet Maker)" (P.96).
116-210 [Cause]
116-211
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
116-212
116-220 [Cause]
[Remedy] Contact our Customer Support Center.
116-310 [Cause]
116-311
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
116-312
116-313
116-314
116-315
116-316
116-317
116-318
116-319
116-321
116-322
116-323
116-324 [Cause]
15 [Remedy] If an error occurred while printing, turn off the machine once, then turn the machine on
590
Cause and Remedy
An error occurred in the machine.
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
An error occurred.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
An error occurred.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
The finisher's hole punch waste container is full.
An error occurred in the USB memory device.
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
Failed to enter the Download mode.
An error occurred in the machine.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
An error occurred in the machine.
holding down both the <Start> and <Stop> buttons simultaneously for six seconds. This
deletes the print data that caused the error. If the error was caused by another reason,
switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact our Customer Support
Center.