Loading Paper In Tray 3 (When Tandem Tray Module Is Installed) - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

1
Pull out the tray until it stops.
Important • While the machine is processing a job, do not
2
Load and align the edge of the paper against
the left edge of the tray, with the side to be
copied or printed on facing up.
Important • Do not load paper above the maximum fill
Note
3
Push the tray in gently until it stops.
Important • When inserting the tray, push it gently. Forcibly pushing the tray in may cause machine malfunction.

Loading Paper in Tray 3 (When Tandem Tray Module is Installed)

The following describes the procedure for loading paper in Tray 3 when the Tandem Tray
Module is installed.
When the machine runs out of paper during copying or printing, a message appears on the
touch screen. Add paper according to the message instructions. Copying or printing
automatically resumes when paper is added.
Note
For information on changing the paper size and orientation, refer to "Changing the Paper Size for Tray 3 (When Tandem
Tray Module is Installed)" (P.67).
pull out the tray that is being used for the job.
• To prevent paper jams or erroneous
detection of loaded paper in a tray by the
machine, do not add paper on top of any
remaining paper in the tray. Remove any
remaining paper from the tray, and then load
that paper on top of the newly loaded paper.
• Do not pull out all the trays at the same time.
Otherwise, the machine gets inclined and
turns over, which may cause injuries.
line ("MAX" in the right figure). It may cause
paper jams or machine malfunction.
• Do not place any paper or objects in the
empty space on the right side of Trays 1 to 4.
It may cause paper jams or machine
malfunction.
• When using punched paper, load the
punched paper as shown in the illustration on
the right.
• Carefully fan the paper before loading it in a tray. Otherwise, the paper may stick together, resulting
in paper jams.
Loading Paper
2
61