Installation Procedures; Step 1 Enabling Port And Setting Up Tcp/Ip - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

11 Using the Internet Fax Service

Installation Procedures

This section describes the configuration procedures to use the Internet Fax feature on the
machine.
The following shows the reference section for each procedure.

Step 1 Enabling Port and Setting up TCP/IP

To use the Internet Fax feature on the machine, enable the ports for the E-mail feature, and
set the IP address. The following shows the configuration procedures on the machine.
Note
For information on how to use CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare
Internet Services" (P.339).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
Note
3) Select [Tools] on the Services Home screen.
2
Enable ports to use for the E-mail feature.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [Receive E-mail], and then select [Change Settings].
11
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close].
7) Select [Enabled] for [Send E-mail - Port Status] on the [Send E-mail] screen as described
8) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining the
address. If an IP address cannot be obtained automatically, or if manual configuration is
preferred, confirm the settings of an IP address, a subnet mask, and a gateway address.
For information on how to set an IP address, refer to "Protocol Settings" (P.219).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].
400
Step 1 Enabling Port and Setting up TCP/IP......................................................................................................................... 400
Step 2 Configuring E-mail Environment................................................................................................................................. 401
Step 3 Testing the Internet Fax ............................................................................................................................................... 402
• You can configure the settings using CentreWare Internet Services.
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
• The default user ID is "11111".
• The default passcode is "x-admin".
above.