Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 729

The <Power Saver> button still lights up when you perform the operations which do not

light up the touch screen such as printing command from a computer.
 A message does not appear on the touch screen if you open and close the top cover of the
document feeder when the document feeder is deactivated (such as when the service to
use a scanner is not selected). However, the confirmation message appears on the touch
screen and the <Error> indicator lights up when the document feeder is activated (exits
the Power Saver mode) while the top cover is open.
 The confirmation indicator does not light up if the document is loaded while the
document feeder is in the Power Saver mode (such as when the service to use a scanner
is not selected). However, the confirmation indicator lights up and the document is
detected when you load the document and then make the machine exit the Power Saver
mode.
 The machine exits the Power Saver mode when you open the document cover to copy or
scan.
After the machine exits the Power Saver mode, the document feeder and scanner device

are activated after the document cover is opened while the scanner device is deactivated.
However, to make the document detected on the document glass, make sure that the
scanner device in the document glass moves to the detect position for the document size,
and then close the document cover.
 After the machine is activated from the Power Saver mode, a message does not appear
on the touch screen if you perform the following operations while the service to be used
for the output device, such as copying and secure printing, is not selected.
- Opening and closing the top cover of the document feeder
- Opening and closing the front cover
- Opening and closing the bottom left cover
- Opening the paper tray
- All the operations including opening and closing the front cover of the finisher, and
pressing the buttons
However, the confirmation message appears and the <Error> indicator lights up when the
machine is activated (exits the Power Saver mode) while each cover or a paper tray is
open.
 After the machine exits the Power Saver mode, the value detected before the machine
enters the Power Saver mode is displayed or informed as paper tray status and the
information on the consumables such as the toner remaining amount, status of the drum
cartridge, and paper, if the service used for the output device is not activated.
After the machine exits the Power Saver mode, be careful for the following if you use the

copy feature before you activate the service used for the output device.
The information displayed such as a paper size specified for the paper tray or the
remaining amount is detected before the Power Saver mode. If you change the paper size
or remaining amount during the Power Saver mode, it takes a few seconds for the change
to be updated on the screen.
 Exiting the Power Saver mode activates the entire machine when Copy, Simple Copy, or
Stored Programming is set as the default screen on the touch screen.
 Exiting the Power Saver mode activates the entire machine when [Paper Tray Attributes
During Loading] is set to [On].
The entire machine exits the Power Saver mode when you press the <Machine Status>

button, enter the System Administration mode, or select the Stored Programming service.
 The machine does not exit the Sleep mode when you use the EP service by EP-BB.
Notes and Restrictions
729
16