Z Fold Half Sheet Position Adjustment - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

8
Select [Sample Printout] again.
9
Select the tray in which you loaded paper, and press the <Start> button.
The sample is printed.
10
Select [Close].
11
Confirm the result of sample printout.
12
Adjust the alignment again if necessary. (Step 5 to 11)
13
Select [Save].
14
Select [Close] until the Services Home screen is displayed.
Note

Z Fold Half Sheet Position Adjustment

Adjust the Z Fold Half Sheet position.
1
Select [Z Fold Half Sheet - A3
Sheet - B4
or [Z Fold Half Sheet - 8K
[Change Settings].
2
Select [Sample Printout].
3
Select the tray in which you loaded paper, and
press the <Start> button.
The sample is printed.
4
Select [Close].
5
Check the printed sample printout, and
measure the A and B fold position movement
amounts.
• When you configure settings under [System Settings] or [Setup] and then press the <Services Home>
button, the screen directly goes back to the Services Home screen.
], [Z Fold Half
], [Z Fold Half Sheet -11x17"
], and then select
Fold Position Adjustment
],
16
673