Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 594

15 Problem Solving
Error Code
116-714 [Cause]
[Remedy] Check the print data.
116-716 [Cause]
116-717
[Remedy] On a computer, confirm the content recorded on the media.
116-720 [Cause]
[Remedy] Stop unnecessary ports or delete unnecessary data to free up disk space.
116-725
[Cause]
[Remedy] Execute the operation again.
116-738 [Cause]
[Remedy] Match the size and orientation of the paper with the form specified, and print again.
116-739 [Cause]
[Remedy] Delete unnecessary data, or free up the space for the form memory.
116-740 [Cause]
[Remedy] Check the print data.
116-741 [Cause]
[Remedy] Delete unnecessary form. The maximum number allowed is 2048.
116-742 [Cause]
[Remedy] Delete unnecessary logo data.
116-743 [Cause]
[Remedy] Increase memory.
116-746
[Cause]
[Remedy] Use the form registered, or register the form.
116-747 [Cause]
15
[Remedy] Decrease the paper margin value, and then execute the operation again.
116-748 [Cause]
[Remedy] Check the print data.
116-749 [Cause]
[Remedy] Install the font, or set the print driver to replace the font.
116-750 [Cause]
[Remedy] Restore the tray to normal condition or change the Banner sheet tray.
594
Cause and Remedy
An HP-GL/2 command error occurred.
An error occurred when reading the data on the media.
An error occurred during print processing because of insufficient memory.
Failed to write the image log because the image log storage area on the machine is
insufficient.
If this error still is not resolved, take one of the following measures:

Delete unnecessary image logs.

Change the [Assurance Level] setting for image logs to [Low].
In this case, selecting [Low] does not secure the contents of created image logs.
The size and orientation of the form specified are not matched with the paper to be
printed.
The form or logo data cannot be registered because memory for the form and logo data
or memory capacity for the hard disk is insufficient.
A numerical value operation error occurred because a value exceeding the value limit of
the machine was used in the print data.
The form cannot be registered because the number of the form registration exceeds the
maximum number allowed.
The logo data cannot be registered because the number of the logo data registration
exceeds the maximum number allowed.
The logo data or form cannot be registered because the memory for the form and logo
data is insufficient.
The form specified is not registered.
The paper margin value is too large for the HP-GL/2 active coordinates area.
There is no plot data in the HP-GL/2 print data.
The job was cancelled because the specified font does not exist.
Banner sheet tray malfunction