Notes And Restrictions On The Use Of The Copy Feature - Fuji Xerox ApeosPort-IV C5575 Administration Manual

Hide thumbs Also See for ApeosPort-IV C5575:
Table of Contents

Advertisement

- Port Status] is set to [Enabled], or [USB] > [USB - Print Mode] is set to any option other
than [Auto], exiting the Energy Saver mode activates the entire machine.
The output device is activated when Secure Print is executed using job tickets of
ContentsBridge Utility.
Opening and Closing of the Document Cover during the Energy Saver Mode
If you open the document cover during the Energy Saver mode, and then start scanning a
document immediately after the machine exits the mode, the detection error of a document
size may occur. In this case, enter the document size manually. It takes a few seconds before
the machine can detect a document size automatically. This detection error will not occur if
you load a document, close the document cover, and wait for a few seconds before start
scanning a document.

Notes and Restrictions on the Use of the Copy Feature

Copy Feature
The machine does not offer the Improves Fit feature.
Meter Count for Dual Color and Single Color Copies
Dual color and single color copies are counted as color copies.
Color Effect for Dual Color Copy
To extract colors for dual color copy, adjusting the colors of the document is required in
advance.
Our service representative performs the adjustment. Contact our Customer Support Center.
Auto Contrast
The machine does not offer the [Auto Contrast] feature for [Color Effects].
Pages per Side for Black & White and Color Mixed Documents and Meter Count
If you copy a document that contains black & white and color pages by specifying [Pages
per Side], an output sheet that has both black & white and color pages will be counted as a
color page.
Copy and Simple Copy
You cannot switch the screen between the Copy and Simple Copy services. Return to the
[Services Home] screen, and then select a service. In that case, the settings specified in either
service are cleared.
IC Card Copy
The machine does not shift the ID card image to the center of the output in any
magnification ratio and image size you specified.
When the reduced size is specified to copy an ID card, the machine may copy the ID card
in a different orientation from the original orientation depending on the magnification
ratio specified.
Notes and Restrictions on the Use of the Print Feature
Output of Long Feed Documents
The output of long feed documents is not supported.
Notes and Restrictions
679
16

Advertisement

Table of Contents
loading

Table of Contents