Fuji Xerox ApeosPort-V C6676 Administrator's Manual page 470

15 Problem Solving
Part of the image
is missing on the
copy.
The copy has a
stripe pattern.
The copy is
misaligned or
skewed.
15
470
Symptom
The paper is damp.
Folded or wrinkled paper is
included in the tray.
The document is pasted or
folded.
The document enlargement
ratio is too large.
The document is not loaded
correctly.
The document guides on the
document feeder are not set
in the correct positions.
The paper tray is not inserted
correctly.
The paper guides in Tray 5
are not set in the correct
positions.
Cause
If the paper is damp, the copy image may be
partially missing or unclear. Replace the
paper with new one.
Refer to "Loading Paper" (P.60).
Remove the unsuitable paper or replace all of
the paper with new one.
Refer to "Loading Paper" (P.60).
The pasted or folded section may not be
laying flat on the document glass. Place a
stack of white sheets on top of the document
to flatten the document against the
document glass.
Vertical stripes may be printed on the copies
depending on the ratio. Adjust the ratio to
eliminate the stripes.
Refer to "3 Copy" > "Copy" > "Reduce/Enlarge (Making
Enlarged/Reduced Copies)" in the User Guide.
Load the document correctly.
Refer to "3 Copy" > "Copying Procedure" in the User
Guide.
Load the document correctly, and align the
document guides to the document.
Refer to "3 Copy" > "Copying Procedure" in the User
Guide.
Firmly push in the tray until it stops to set it
properly.
Refer to "Loading Paper" (P.60).
Load the paper correctly, and align the paper
guides to the paper edges.
Refer to "Loading Paper in Tray 5 (Bypass Tray)" (P.63).
Remedy