Installation When Using Tcp/Ip (Lpd/Port 9100); Step 1 Preparations; Step 2 Configuration On The Machine - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

Installation When Using TCP/IP (LPD/Port 9100)

This section describes how to install the machine using TCP/IP.
The following shows the reference section for each procedure.

Step 1 Preparations .....................................................................................................................................................................351

Step 2 Configuration on the Machine.....................................................................................................................................351

Step 3 Configuration on the Computer ..................................................................................................................................352
CentreWare Internet Services Setting Items.........................................................................................................................352
Step 1 Preparations
The following items are required to use the machine via TCP/IP (LPD/Port9100).
TCP/IP network environment

 Media (Software/Product Manual) provided with the machine
Step 2 Configuration on the Machine
The following describes the configuration procedures to use TCP/IP (LPD/Port9100) on the
machine. Enable the LPD Port or the Port9100 port, and then configure TCP/IP settings.
Note
For the items that can be configured using CentreWare Internet Services, refer to "CentreWare Internet Services Setting
Items" (P.352). For information on how to configure the setting using the Media (Software/Product Manual), refer to the
manual contained in the Media (Software/Product Manual).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note
3) Select [Tools] on the Services Home screen.
2
Enable the LPD port or Port9100 port as appropriate.
In this example, the LPD port is enabled.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [LPD], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining the
• You can configure the settings using CentreWare Internet Services or the Media (Software/Product
Manual).
• The default user ID is "11111".
• The default passcode is "x-admin".

Installation When Using TCP/IP (LPD/Port 9100)

7
351