Smtp Server Settings - Fuji Xerox ApeosPort-V C3320 Administrator's Manual

The default value is 110.
Important • Do not use the numbers assigned to the other ports.
Polling Interval
Set the interval for checking the e-mail on the POP3 server from 1 to 120 minutes in 1
minute increments.
Login Name
Enter the name to login to the POP3 server with up to 64 characters.
Password
Enter a password for the POP3 server with up to 64 characters.
Enter the same password in [New Password] and [Retype Password] using the numeric
keypad displayed by selecting [Keyboard]. If you do not set the password, leave the text
boxes blank and select [Save].
POP Password Encryption
Select [On (APOP)] to encrypt the password.

SMTP Server Settings

Set the SMTP server. In [SMTP Server Settings], you can set the following items:
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
• When you make an entry mistake, press the <C> (Clear) button and enter again.
SMTP Server Name/IP Address
Enter a server name or IP address, and then select [Save]. Up to 128 characters are allowed.
SMTP Server Port Number
Enter a port number in the range from 1 to 65535.
The default value is 25.
Important • Do not use the numbers assigned to the other ports.
E-mail Send Authentication
Select one from [Off], [POP before SMTP], or [SMTP AUTH].
Note • If [POP before SMTP] is selected, the POP3 settings must be set.
• AUTH GSSAPI (only for Kerberos), AUTH NTLMv2, AUTH NTLMv1, AUTH PLAIN, AUTH-LOGIN, or
Login Credentials for E-mail Send
Select the login user name when sending e-mails from [Remotely Authenticated User] and
[System]. When [Remotely Authenticated User] is selected and if the machine tries
authenticating the remote server before a job startup, the machine performs verification at
the time of transmission with the remotely authenticated user name and password. You can
also select the post-failure behavior of the machine from [Cancel E-mail Send] and [Relogin
using System Data]. If you do not set remote authentication, the machine uses the user ID
and passcode of the machine for authentication.
SMTP AUTH Login Name
Enter the user name for verification purposes at the SMTP server with up to 64 characters.
255.
hexadecimal value.
AUTH CRAM-MD5 can be used as an authentication method.
Connectivity & Network Setup
179
5