Rear Wiper Motor Inspection - Suzuki 2006 SX4 Service Manual

Rear Wiper Motor Inspection

NOTE
Make sure that battery voltage is 12 V or
more.
1) Make a mark (1) on rear wiper motor (2) stop
position as shown.
2
2) Check rear wiper motor for operation as follows.
• For motor operation
a. Connect battery positive terminal to terminal
"1" and its negative terminal to terminal "2".
b. Check if motor reciprocation speed is as
specification. If check result is not as
specified, replace motor.
Specification
35 – 45 r/min (rpm)
1
2 3
S6RW0C9406007
1
I5RW0A940013-02
I5RW0A940014-01
• For automatic stop operation
a. Connect battery positive (+) terminal to
terminal "1" and its negative (–) terminal to
terminal "2" and let the motor turn.
b. Disconnect terminal "2" from battery negative
(–) terminal and let the motor stop.
c. Observe the motor (4) turns once again then
stops at a specified position as shown.
4
1
2 3
5. Mark
d. Repeat Step a. to c. several times and check
that the motor stops at the specified position
every time.
If check result is not satisfied, replace motor.
Wipers / Washers: 9D-7
5
I5RW0A940015-02