Fuel Level Sensor Removal And Installation; Fuel Level Sensor Inspection; Oil Pressure Switch Removal And Installation; Oil Pressure Switch Inspection - Suzuki 2006 SX4 Service Manual

Fuel Level Sensor Removal and Installation

Removal
Remove fuel pump assembly referring to "Fuel Pump
Assembly Removal and Installation in Section 1G".
Installation
Install fuel pump assembly referring to "Fuel Pump
Assembly Removal and Installation in Section 1G".

Fuel Level Sensor Inspection

• Check that resistance between terminals "a" and "b"
of fuel level sensor changes with change of float
position.
• Check resistance between terminals "a" and "b" at
each float position in the following.
If the measured value is out of specification, replace.
Fuel level sensor specifications
Float Position
204 mm
Full Upper "c"
(8.03 in.)
32 mm
Full Lower "d"
(1.26 in.)
"a" "b"
2
"c"
"d"
1. Fuel pump

Oil Pressure Switch Removal and Installation

For removal and installation, refer to "Oil Pressure
Check in Section 1E".
S6RW0C9306004
S6RW0C9306005
Resistance (Ω)
40 ± 2
280 ± 3.3
1
I7RW01930008-01
2. Float
S6RW0C9306006
Instrumentation / Driver Info. / Horn:

Oil Pressure Switch Inspection

1) Disconnect oil pressure switch (1) lead wire.
2) Check for continuity between oil pressure switch
terminal (2) and cylinder block (3) as shown.
If check result is not as specified, replace oil
pressure switch (1).
Oil pressure sensor specification
During engine running: No continuity
At engine stop: Continuity
Engine Coolant Temperature (ECT) Sensor
Inspection
Check engine coolant temperature sensor for resistance,
refer to "Engine Coolant Temperature (ECT) Sensor
Inspection in Section 1C".
9C-16
S6RW0C9306007
I7RW01930009-01
S6RW0C9306008