4) Check that the voltmeter indicates the battery
voltage (10 – 14 V).
5) Connect terminal "3" and terminal "5" by a jumper
wire.
[B]
5
4
[A]: RHD without rear fog light
[B]: Other than RHD without rear fog light
6) Disconnect end of the jumper wire from terminal "5".
7) Connect disconnected jumper wire end to terminal
"2", then check that voltage between terminal "4" and
terminal "2" changes as shown.
If check result is not satisfied, replace switch.
[D]
10-14V
0V
INT
TIME
10-14V
INT
TIME
0V
[B]
5
4
[A]: RHD without rear fog light
[B]: Other than RHD without rear fog light
[C]: Voltage
[D]: INT time control switch position
[E]: 1.6 ± 1 sec.
[F]: 10.7 ± 5 sec.
2
2
[A]
3
4
5
3
V
I5JB0D940002-02
[C]
[E]
[F]
2
2
[A]
3
4
5
3
V
I5JB0D940003-02
Washer Linked Circuit
1) Make sure that front wiper switch is at "OFF"
position.
2) Connect battery positive (+) terminal to terminal "5"
and its negative (–) terminal to terminal "2".
3) Connect voltmeter positive lead to terminal "4" and
its negative lead to terminal "2".
4) When front washer switch is ON, check that voltage
changes as shown in figure.
If check result is not satisfied, replace switch.
ON
[C]
OFF
High
[D]
Low
[B]
5
4
[A]: RHD without rear fog light
[B]: Other than RHD without rear fog light
[C]: Wiper switch
[D]: Voltage
[E]: Approx. 2.2 sec.
[F]: Approx 0.3 se.
Wipers / Washers:
[E]
[F]
2
2
[A]
4
5
V
I5JB0D940004-02
9D-9