Front Fog Light Assembly Removal And Installation (If Equipped); Front Fog Light Switch Inspection (If Equipped); Front Fog Light Aiming Adjustment With Screen (If Equipped) - Suzuki 2006 SX4 Service Manual

9B-28 Lighting Systems:
Front Fog Light Assembly Removal and
Installation (If Equipped)
WARNING
!
• To avoid danger of being burned, don't
touch when the bulb is hot.
• Don't touch glass surface of bulb to avoid
deteriorate as the case may be unclear
when bulb light on at dirty condition.
Removal
1) Disconnect negative (–) cable at battery.
2) Remove front bumper. Refer to "Front Bumper and
Rear Bumper Components in Section 9K".
3) Disconnect coupler from fog light (1).
4) Detach fog light pushing clips to arrow direction.
1
Installation
Reverse removal procedure for installation nothing the
following:
• After installing, adjust aiming referring to "Front Fog
Light Aiming Adjustment with Screen (If Equipped)".

Front Fog Light Switch Inspection (If Equipped)

NOTE
Front fog lights light up only when headlight
switch is in HEADLIGHT position (low or high
beams) or SMALL position. Front fog lights
turn OFF automatically when headlight
switch is turned to OFF position. If front fog
light switch holds ON position, front fog
lights turn ON automatically when headlight
switch is tuned to HEADLIGHT position (low
or high beams) or SMALL position again.
Check for continuity between terminals at each switch
position. If check result is not as specified, replace
switch.
S6RW0C9206014
Switch Position
ON (PUSH IN)
Front Fog Light Aiming Adjustment with Screen
(If Equipped)
Basic Aiming
NOTE
• Unless otherwise obligated by local
I6RW0B920006-01
regulations, adjust front fog light aiming
according to the following procedure.
• An example in case that the light-to-wall
distance 10 m is shown in the illustration.
The beam descending distance "H" is
calculated when "a" is 10 m with the
specification angle "b" (1.14°).
S6RW0C9206016
1) Make sure the following items.
• Place vehicle on a flat surface in front of blank wall
(screen) (1) ahead of front fog light surface.
Distance between screen and front fog light
"a": 10 m (32.8 ft.)
• Adjust air pressure of all tired to the specified
value respectively.
• Bounce vehicle body up and down by hand to
stabilize suspension.
• Carry out aiming with a driver aboard.
Driver's weight
75 kg (165 lb)
1
2
3
4
5
Terminal
2 3
OFF
1
5 4
I4RS0A920021-01
S6RW0C9206018