Avaya DEFINITY Server CSI Maintenance Manual page 923

CO-TRK (CO Trunk)
Table 161. TEST #0 Dial Tone Test
Error Test
Code Result
ABORT
1000 ABORT
1001 ABORT
1002 ABORT
1004 ABORT
1005 ABORT
1018 ABORT
2000 ABORT
555-233-119
Description/ Recommendation
Could not allocate system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
System resources required to run this test are not available. The port may
be busy with a valid call. Use the command display port PCSSpp to
determine the trunk group/member number of the port. Use the status
trunk command to determine the service state of the port. If the service
state indicates that the port is in use, the port is unavailable for certain
tests. Wait until the port is idle before retesting.
1. If the port status is idle, retry the command at 1-minute intervals a
maximum of 5 times.
System resources required to run this test were not available. This could be
due to a failure to seize the port.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors. Refer to TDM-BUS (TDM Bus) Maintenance
documentation to diagnose any active TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
repeat test at 1-minute intervals a maximum of 5 times.
The port was seized by a user for a valid call. Use the display port
PCSSpp command to determine the trunk group/member number of the
port. Use the status trunk command to determine the service state of the
port. If the service state indicates that the port is in use, the port is
unavailable for certain tests. W wait until the port is idle before retesting.
1. If the port status is idle, retry the command at 1-minute intervals for a
maximum of 5 times.
Trunk has been administered as incoming-only; dial tone can only be
obtained on outgoing trunks. This is a normal condition.
Test has been disabled via administration.
1. Verify that the Maintenance Tests
is set to n. To enable the test, use change trunk-group x where "x"
equals the number of the trunk group to be tested, and set the
Maintenance Tests
Response to the test was not received within the allowable time period.
1. Retry the command at 1-minute intervals a maximum of 5 times.
field on the Trunk Group Form
field to y.
Continued on next page
Issue 5 October 2002
923