Test Interface - Avaya DEFINITY Server CSI Maintenance Manual

test interface

test interface
Use test interface to run hardware diagnostic tests on the processor interface
circuit pack. The tests also examine the protocol and link interface that is
transmitted over the board.
Action/Object Qualifier
test interface location
short
long
repeat
number
clear
schedule
1 If no alarms are registered against the maintenance object then the test sequence is run only once. The long
clear option forces a clear of all alarms if no errors are encountered during testing. The short clear option only
clears alarms pertinent to tests in the short sequence. SEE WARNING BELOW.
2 See the Report Scheduler and System Printer feature specification for more details.
!
WARNING:
Since the "clear long" options clear all counters if tests pass, it is possible for
firmware counters to be cleared even when a problem exists. In some cases
customer service might degrade since calls may be routed over defective
equipment.
555-233-119
Qualifier Description
Location (cabinet-carrier-position) of
the processor interface (position 1 =
first processor interface in the carrier,
2 = second)
Option for a brief series of
nondestructive diagnostic tests.
Option for a longer, more
comprehensive series of both
destructive and nondestructive
diagnostic tests.
Number of times each test in the
sequence is repeated (1-100)
This option causes the test sequence
(short or long) to repeat until the alarm
(if any) is cleared or a single test in the
1
sequence fails.
Use the screen to schedule execution
of the command. The command is
placed in the command queue and is
executed at the specified time. The
information displayed by the command
is sent to the system printer instead of
2
the screen.
Examples:
test interface 01a1 l
test interface 01b2 s r 2
test interface 01b2 s r 2 schedule
test interface b1 l r 25
test interface a2
Feature
Logins Defaults Interactions
init Test none
inads sequence
craft = short;
nms repeat = 1
Issue 5 October 2002
561