Avaya DEFINITY Server CSI Maintenance Manual page 1340

Maintenance Objects
General Information about log-svn Error Log
Entries
a. The number (1 - 15), that appears in the error type field, corresponds to the
location the login in the internal login data structure.
b. The Alt Name field on the alarm report indicates the login ID associated
with the security violation and major alarm.
c. These errors/alarms are associated with a number of failed attempts to
access the system management/maintenance interface using a services
login ID that meet or exceed the customer administered threshold
parameters. The associated alarm is immediately raised as a major alarm.
d. The affected login ID will be disabled as a result of detection of the security
violation, unless it is the last enabled INADS type login on the system. The
provision to disable a login ID following detection of a security violation
involving that login ID is administrable on a login ID basis.
e. The enable login command is used to both enable a login that has been
disabled, and to retire any login security violation alarms associated with
the login ID.
f. Use of the enable login command to enable a login and/or retire alarms
must be executed using a login ID with greater service level hierarchy
permissions.
g. Access to the enable login command is controlled through the
Administer Permissions field on the Command Permission
Categories form. This field (Administer Permissions) must be set to y to
access the enable login command.
h. The Port alarm report field will set to the port where the final invalid login
attempt, involving the alarmed login ID, was detected. Valid port values for
the CMC include:
— MGR1 — Dedicated manager 1 or G3 management terminal
— NET-n — Network controller dial up port
— INADS — INADS port
— EPN — EPN maintenance EIA port
— EIA — Other EIA port
i. The Svc State alarm report field will be set to OUT if the login ID is in the
disabled state as a result of detection of a security violation involving the
login ID. Once the login ID has been enabled, the field is set to IN.
1340
Issue 5 October 2002
connection