Avaya DEFINITY Server CSI Maintenance Manual page 1228

Table 280. TEST #1387 H.323 Signaling Group Ping Test — Continued
Error Test
Code Result
1005 ABORT
1125 ABORT
2000 ABORT
2012 ABORT
2100 ABORT
2500 ABORT
2800 ABORT
2801 ABORT
1228
Issue 5 October 2002
Description/ Recommendation
Configuration for this test is incorrect.
Verity that the link is in-service with the status port or status link
command. Verify that the routing table has destinations that are
reachable through this port.
Repeat the test.
If the test aborts with Error Code 7, while step 1 verified, escalate the
problem.
Link is not in service.
Check if the link is in-service or not. If the link is not in service,
release the link using release link or release port command and
repeat the test. This is a normal abort.
If the test continues to abort after following the repair procedures,
escalate the problem.
Response to the test was not received from the CLAN circuit pack
within the allowable time period.
If this result occurs repeatedly, attempt to reset the circuit pack if the
other ports on the board are not in use (Yellow LED is off). Reset the
circuit pack by issuing the busyout board UUCSS, reset board
UUCSS, and release board UUCSS commands.
If this result occurs again, replace the circuit pack.
Internal system error.
Retry the command at 1-minute intervals a maximum of 3 times.
The necessary system resources to execute the test could not be
allocated.
Retry the command at 1-minute intervals a maximum of 5 times.
Internal system error.
Retry the command at 1-minute intervals a maximum of 3times.
No CLAN in the same region.
Verify translations and retest.
No IP address defined.
Verify translations and retest.
Continued on next page
555-233-119