Avaya DEFINITY Server CSI Maintenance Manual page 910

Maintenance Objects
Table 158. TEST #314 DS1CO Dial Tone Seizure Test
Error Test
Code Result
ABORT
1000 ABORT
1004 ABORT
1005 ABORT
1018 ABORT
910
Issue 5 October 2002
Description/ Recommendation
Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
The test was aborted because system resources required to run this test
were not available. The port may be busy with a valid call. Use display port
PCSSpp to determine the trunk group/member number of the port. Use
status trunk to determine the service state of the port. If the service state
indicates that the port is in use, the port is unavailable for certain tests. Wait
until the port is idle before retesting.
1. If the port status is active but the port is not in use (no calls), check the
error log for error type 1025 (see the error log table for a description of
this error and required actions). The port may be locked up.
2. If the port status is idle, retry the command at 1-minute intervals for a
maximum of 5 times.
The test was aborted because the port was seized by a user for a valid call.
Use display port PCSSpp to determine the trunk group/member number of
the port. Use status trunk to determine the service state of the port. If the
service state indicates that the port is in use, the port is unavailable for
certain tests. Wait until the port is idle before retesting.
1. If the port status is idle, retry the command at 1-minute intervals for a
maximum of 5 times.
Test failed due to incompatible configuration administered in trunk group
form.
1. Verify the following fields on the trunk group administration screen: Is
trunk direction incoming only? Is trunk the port 24 of the DS1 Interface
circuit pack while common control channel signaling is specified? Is
trunk group type the automatic CO (for example, FX)?
2. If the trunk has been administered using the above information, this test
should abort.
The test is disabled via translation. You may want to determine why the test
has been disabled before you enable it.
1. Verify that the Maintenance Test
set to n. To enable the test, issue change trunk-group x where x
equals the number of the trunk group to be tested. Set the
Maintenance Test
2. Repeat the test.
field on the Trunk Group form is
field to y.
Continued on next page
555-233-119