Avaya DEFINITY Server CSI Maintenance Manual page 459

status conference
Drop
"Pre-AnsDrop" = The call disconnects an endpoint answers. The network,
Reason
an endpoint, or a terminal adapter may cause the disconnect. This drop
(cont'd)
reason differs from 'No-answer,' which indicates that a 60-second timeout
occurs during alerting. In this case, the call drops before the 60-second
timer expires. Some busy endpoints that are connected through terminal
adapters display this behavior.
"Resource" = MCU cannot provide resources (VC or MMI) when calls
arrive or lose their resources during the call. Calls can lose resources
when they are Out of Service, busied out by craft, or in use by system
maintenance. If the DS1/MMI cable is disconnected, this drop reason can
also occur. If a resource problem exists when the call arrives, it gets
reorder (fast busy) and is not disconnected by the MCU.
"Password" = The user enters a wrong password or the audio add-on user
does not enter it within the specified time period. The audio add-on user
gets one attempt to enter a correct password and has about 10 seconds
between digits (inter-digit timing).
"System" = MCU restarts (level 2) disconnect all calls.
"UIN-Inv" = Users enter invalid User Identification Numbers.
"Unknown" = The system cannot determine the disconnect cause.
"Wrong-num" = The MCU CPTR resources SDN cause values detect an
incorrectly-dialed destination number. See "Dial-out" for details.
"UCC" = The controller intentionally disconnects the endpoint.
A detail code complementing the Drop Reason. Additional bonding-related
Drop Code
information is available from the supplementary BONDing Drop Codes
described above.
Administered Connection Numbers. (1–128) AC numbers can further
AC Num
diagnose problems by combining status conference information with the
status administered connection command, and data stored in the error
and alarm logs.
The data endpoint that the channel is using.
Ports
Trunk
The MMI port for the channel.
Ports
Video
If the endpoint type is not "UCC," the VC audio encoder port (which is
Ports Aud
always paired to a decoder port) for the channel (only the first channel).
appears together with the ESM data port in the endpoint's channel 1 port
slot position of the Port Aud/ESM column. For "UCC" endpoints, the
channel 1 port slot position displays allocated Call Classifier resources.
Expansion Service Module MMI data port. This field is always blank.
Ports ESM
The MMI port used for channel BONDing.
Ports
BONDng
Frame error counter. A circular hex counter (0-FF) to indicates framing
Fr Err
error occurrences.
555-233-119 Issue 5 October 2002
459