Avaya DEFINITY Server CSI Maintenance Manual page 651

ANL-24-L (24-Port Analog Line)
Table 42. TEST #48 Station Present Test
Error Test
Code Result
ABORT Could not allocate the necessary system resources to run this test.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1004 ABORT The port was seized by a valid call during the test. The test has been
aborted.
1005 ABORT The test was aborted due to a configuration problem. This test may not be
applicable or it may be disruptive to terminal equipment other than a voice
terminal (for example, the modem pool member or Music On Hold).
1008 ABORT Could not allocate a ringing circuit. Either all the ringing circuits are in use or
the ringing generator is defective or it is not wired correctly.
1018 ABORT The test has been disabled by administration.The default for the
on the station screen is y. Determine why this field has been set to
station (this may be due to the brief ringing disturbance that this test may
cause).
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate necessary system resources to run this test.
555-233-119
Description/Recommendation
1. Retry the command at 1-minute intervals a maximum of 5 times.
1. Use display port PCSSpp command to determine the station
extension.
2. Use status station to determine the service state of the port.
3. If the port is in use, wait until the port is idle and retry the command at
1-minute intervals a maximum of 5 times.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, look for RING-GEN errors in the Error Log.
If an ABORT 1008 occurs for this test on other circuit packs as well, the
ringing generator may be defective or is not wired correctly (see errors
for RING-GEN). If it does not occur on other ports, all four ring phases
are in use.
1. To enable the test for a particular station being tested, enter change
station extension and set the
1. Retry the command at 1-minute intervals a maximum of 5 times.
Test field on the Station screen to y.
Continued on next page
Issue 5 October 2002
Test field
n on this
651