Avaya DEFINITY Server CSI Maintenance Manual page 1424

Maintenance Objects
System Technician-Demanded Tests: Descriptions
and Error Codes
Always investigate tests in the order presented in the table below when inspecting
errors in the system. By clearing error codes associated with the NPE Crosstalk
Test, for example, you may also clear errors generated from other tests in the
testing sequence.
Order of Investigation
NPE Crosstalk Test (#6)
Conference Circuit Test (#7)
DS1OPS Switchhook Inquiry Test (#312)
Audit and Update Test (#36)
1. D = Destructive; ND = Nondestructive
NPE Crosstalk Test (#6)
One or more NPEs reside on each circuit pack with a TDM Bus interface. The
NPE controls port connectivity and gain, and provides conferencing functions on a
per-port basis The NPE Crosstalk Test verifies that this port's NPE channel talks
on the selected time slot and never crosses over to time slots reserved for other
connections. If the NPE is not working correctly, one-way and noisy connections
may be observed. This test is usually only part of a port's Long Test Sequence
and takes about 20 to 30 seconds to complete.
Table 374. TEST #6 NPE Crosstalk Test
Error Test
Code Result
ABORT
1000 ABORT
1001 ABORT
1424
Issue 5 October 2002
Description/ Recommendation
Could not allocate system resources to run this test or an internal system
error (software) occurred.
1. Retry the command at 1-minute intervals a maximum of 5 times.
System resources required to run this test are not available. The port may be
in use on a valid call. Use status station or status trunk command to
determine when the port is available for testing.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Short Test Long Test
Sequence Sequence
X
X
X X
X X
Continued on next page
1
D/ND
ND
ND
ND
ND