Avaya DEFINITY Server CSI Maintenance Manual page 665

ANL-LINE (8-Port Analog Line), ANL-NE-L (8-Port Neon
Analog Line)
Table 46. TEST #35 Battery Feed Test — Continued
Error Test
Code Result
0 NO
BOARD
Station Status and Translation Audits and
Updates Test (#36)
This test updates the analog port's message lamp state (if it has one) and
translations (such as station type, dial type, network connection) with information
kept in the software. The software is updated with the switchhook state reported
by the port processor. When the ringer is in the off state, this test also turns off the
station's ringer to prevent constant ringing caused by defective hardware.
Table 47. TEST #36 Station Status and Translation Audits and Updates Test
Error Test
Code Result
ABORT
1004 ABORT
555-233-119
Description/ Recommendation
The test could not relate the internal ID to the port (no board). This could be
due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Check to ensure that the board translations are correct. Use list config,
and resolve any problems that are found.
2. If the board was found to be correctly inserted in step 1, use busyout
board.
3. Issue reset board.
4. Issue release busy board.
5. Issue test board long. This should re-establish the linkage between
the internal ID and the port. If this is not the case, dispatch to check to
ensure that there is a valid board inserted.
Description/ Recommendation
Could not allocate the necessary system resources to run this test.
System resources required to run this test are not available. The port may
be busy with a valid call. Use display port PCSSpp to determine the station
extension. Use status station to determine the service state of the port. If
the service state indicates that the port is in use, the port is unavailable for
certain tests. (Refer to the "Status Commands" section in Chapter 8,
"Maintenance Commands and Trouble-Clearing Aids", for a full description
of all possible states.) Wait until the port is idle before retesting.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
Continued on next page
Issue 5 October 2002
665