Avaya DEFINITY Server CSI Maintenance Manual page 627

ADX16D-P (16-Port AUDIX Digital Port)
Table 32. TEST #9 NPE Crosstalk Test — Continued
Error Test
Code Result
1000 ABORT
1001 ABORT
1002 ABORT
1003 ABORT
1004 ABORT
1020 ABORT
2000 ABORT
1 FAIL
2
555-233-119
Description/Recommendation
System resources required to run this test are not available. The port may
be in use. Use display port PCSSpp to determine the voice port extension
of the port. Use status station to determine the service state of the port. If
the port is in use, it is unavailable for certain tests. Refer to "Status"
commands in Chapter 8, "Maintenance Commands and Trouble-Clearing
Aids", for a full description of all possible states. Wait until the port is idle
before testing.
1. If the port status is idle, retry the command at 1-minute intervals a
maximum of 5 times.
System resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service due
to TDM-BUS errors.
1. If system has no TDM-BUS errors, and if it is not handling heavy traffic,
retry the command at 1-minute intervals a maximum of 5 times.
The system could not allocate a tone receiver for the test. The system may
be oversized for the number of tone detectors present, or some tone
detectors may be out-of-service.
1. Resolve any "TTR-LEV" errors in the Error Log.
2. Resolve any "TONE-PT" errors in the Error Log.
3. Retry the command at 1-minute intervals a maximum of 5 times.
The port was put in use during the test. The test has been aborted. Use
display port PCSSpp to determine the voice port extension of the port. Use
status station to determine the service state of the port. If the port is in use,
it is unavailable for certain tests. Refer to "Status" commands in Chapter 8
for explanations of all possible states. Wait until the port is idle before
testing.
Test disabled via background testing. Use status station to determine
when the voice port is available for testing.
Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The NPE of the tested port was found to be transmitting in error. This
causes noisy and unreliable connections. Failure code 1 indicates that the
Crosstalk test failed on the primary channel. Failure code 2 indicates that
the Crosstalk test failed on the secondary channel.
1. Replace the circuit pack (see caution at the beginning of this section).
Continued on next page
Issue 5 October 2002
627