Avaya DEFINITY Server CSI Maintenance Manual page 992

Table 186. TEST #7 Conference Circuit Test
Error Test
Code Result
ABORT Could not allocate the necessary system resources to run this test.
1000 ABORT System resources required to run this test were not available. The port may be
busy with a valid call. Use the display port PCSSpp command to determine
the trunk group/member number of the port. Use the status trunk command
to determine the service state of the port. If the service state indicates that the
port is in use, then the port is unavailable for certain tests. You must wait until
the port is idle before retesting.
1002 ABORT The system could not allocate time slots for the test. The system may be under
heavy traffic conditions, or it may have time slots out of service due to
TDM-BUS errors. Refer to the TDM-BUS (TDM bus) Maintenance
documentation to diagnose any active TDM-BUS errors.
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of tone detectors present or some of the tone
detectors may be out of service. Issue the list measurements tone-receiver
command to display basic information about the system's tone receivers.
1004 ABORT The port was seized by a user for a valid call. Use the display port PCSSpp
command to determine the trunk group/member number of the port. Issue the
status trunk command to determine the service state of the port. If the service
state indicates that the port is in use, then the port is unavailable for certain
tests. You must wait until the port is idle before retesting.
992
Issue 5 October 2002
Description/ Recommendation
1. Retry the command at 1-minute intervals a maximum of 5 times.
1. If the port status is active but the port is not in use (no calls), check the
error log for error type 1025 (see the Error Log table for a description of
this error and required actions). The port may be locked up.
2. If the port status is idle, retry the command at 1-minute intervals for a
maximum of 5 times.
1. If the system has no TDM-BUS errors and is not handling heavy traffic and
the port status is idle, retry the command at 1-minute intervals for a
maximum of 5 times.
1. Look for TTR-LEV errors in the error log. If present, refer to the TTR-LEV
Maintenance documentation.
2. Look for TONE-PT errors in the error log. If present, refer to the TONE-PT
Maintenance documentation.
3. If neither condition exists, retry the test at 1-minute intervals for a
maximum of 5 times.
1. If the port status is idle, retry the command at 1-minute intervals for a
maximum of 5 times.
Continued on next page
555-233-119